User guide

ManualsBrandsConair ManualsKitchen AppliancesA1-5

TrueFeed manual

INJECTION MOLDING

The following parameters can be seen in the Production screen, depending on operation or settings made

within the Supervisor user level:

Injection molding / Gravimetric mode

Production Settings

Ref.Curve: Type of reference curve: pre-programmed curve or user-defined curve.

Prod Job : Name of the production Job

Material : Name of material calibration

Color % : Color amount (%)

Shot wth : Shot weight (gr.)

Dos. time : Feeding time (sec.)

Feeding time is only visible in Timer mode

Save job : Save actual production settings into a job

Test: : Initial production test with set speed and time

Actual production data

Col.set. : Calculated output (gr/sec)

Col. act. : Actual color output (gr/sec)

Actual color output is only visible after the first automatic RPM adjustment.

Hopper : Material weight in the hopper

>< : Standstill sign. When the vibrations are too large, this sign disappears!

Time : -Count down of the actual feeding time (sec), when running in TIMER input mode.

-Average feeding time (sec), when running in RELAY input mode.

Speed : Actual motor speed (RPM)

Status : Status of the feeding: Standby / Feeding / Filling

Injection molding / RPM mode

Production Settings

Prod Job : Name of the production Job

Set speed : Set motor speed (RPM)

Dos.time : Actual feed time (sec), measured from relay

Save job : Save production settings into a job

Test: : Initial production test with set speed and time

Actual production data

Speed : Actual motor speed (RPM)

Time : Count down of the actual feeding time (sec)

Status : Status of the feeding: Standby / feeding / filling

 RPM mode always needs a set feeding time, relay function is not applicable.

PRODUCTION SETTINGS

Ref.Curve: MOVA/USER

Prod Job : xxxxxxxx

Material : xxxxxxxx

Color % : x.xxx %

Shot wth.: xxxx.x gr

Dos.time : xx.x s

Save job : NO/YES

Test : NO/YES

PRODUCTION DATA

Col.Set. : x.xxx gr/s

Col.Act. : x.xxx gr/s

Hopper : xxxx gr ><

Time : xx.x sec

Speed : xxx.x rpm

Status : Feeding