User guide

Operation TrueBlend™
50 Edition: February 2008
7.4 Starting and stopping the blending process
7.4.1 Starting blender process (with set values or factory setting)
Î Press the blender icon.
The “TrueBlend Status” screen opens.
Î Press the
button to start the blending
process automatically with the last set values
or the factory settings.
The button signals
. (green bar)
7.4.2 Stopping the blending process
Î Press the
button to stop the metering
and mixing process.
The button changes to
(yellow bar). The
current batch will run until it is finished. When fin-
ished the display changes to
(gray bar).
NOTE
The bar will remain yellow until the batch of material has been dumped. The
batch will not dump until there is sufficient room in the weigh bin and the level
sensor is exposed. A green square on the screen indicates that the mixing
chamber is full and that the weigh bin has no place to put the current batch until
the material level in the mix chamber is lowered.
This green
square
indicates that
the mixing
chamber is
full, and the
level sensor
is satisfied.