User guide

Operation TrueBlend™
110 Edition: February 2008
Î To set this system up, enter the
loader configuration screen on
blender 2.
Any loader on blender 2 that will be using
the blower on blender 1 should have it’s
WCN value changed to the last three
digits (octet) of blender 1 as shown. In
this example the WCN is changed from
240 to 249.
The LCO value refers to the type of device (19=loading, 18=blower) and
should never be changed except under direction of Conair service or
engineering personnel. The complete system and settings for this example
is shown below.