User guide

Operation l 4-35

To Stop Drying

1 Press the STOP button. The Stop LED blinks red.

• The blowers continue running for a few minutes

to cool the heaters.

2 Be sure to disconnect and lockout the main power if you have stopped the

dryer to perform maintenance or repair.

IMPORTANT: Do not use the main power switch to stop the dryer. Turning off power to the

control and dryer during normal operation prevents the necessary cool-down period, and

can trigger the shut down/high temperature alarm during your next drying cycle.

Caution: Improper shut down can cause damage to your dryer.

NOTE: Turn off the ResinWorks or HTC and allow the heaters to cool (3 to 5 minutes)

before turning off the dryer.

✐

Stop

Operation

To Start Drying (continued)

3 Press the START button.

If everything is installed correctly:

Start

• The green light on the start button will illuminate.

• The process and regeneration blowers turn on and the display

LEDS will illuminate.

• The regeneration heater turns on and the display LED will

illuminate.

• The desiccant wheel starts turning.