User guide

4-34 l Operation
To Start Drying
1 Make sure there is material in the hopper.
2 Turn on the main power to the dryer. Make sure the dryer’s disconnect dial
is in the ON position. This powers up the control and the display lights will
illuminate.
1
2
3
4
5
6
7
8
9
Clear
0
Enter
Adjust Setpoint
Acknowledge
Alarm
Start
Stop
Select
Category
Menu
Scroll List
Prev
Next
Auto Start
Dewpoint Control
Process Blower Regen. Blower
Regen. Heater
1000
3
3
NOTE: Once the dryer has been started, go to the ResinWorks or HTC and set the
setpoint then turn on the unit.
✐
NOTE: When changing a setpoint use the Select Category Key directly below the value
to be changed. Once pressed the value will blink, then use the keypads or (+) (-)
adjustment setpoints to enter the new value. Then press enter for the new value to be
recognized.
✐
Setpoint
Adjustment
Buttons
Select
Category
Buttons
(continued)