User guide

Operation l 4-29
4
Operation
Function
Control Function Descriptions
(continued)
This screen shows the password entry
screen. You can enter a password by using
the keypad. Once a password has been
entered the “ENTER” key must be
pressed. If the password is valid, the
display will show screen 87. If the
password was incorrect, it will display
"Invalid Password Try Again" and go back
to the Enter Password screen. The default
supervisor password is 0210. The
supervisor can change this password by
going to screen 89.
This is the Reset Password screen. It will
only be shown when the second and fourth
Select Category buttons are pressed at the
same time when at screen 85. You can
enter the default password by using the
keypad. Once the default password has
been entered, the “ENTER” key must be
pressed. This will change the password
back to the factory default password (see
page 4-29, screen 85). If the password has
been changed see screens 89 and 90.
This is the display screen that appears
when a valid password has been entered.
Pressing the Previous button will take you
to screen 14. Pressing “Next” will take
you to screen 88.
Screen
SCREEN 85
SCREEN 86
SCREEN 87
ENTER PASSWORD
0210
RESET PASSWORD
VALID SUPERVISOR
PASSWORD ENTERED