User guide

Screen
SCREEN 11 Dewpoint Control
and/or Dewpoint Monitor
SCREEN 12 (MAIN MENU)
This screen will show the actual dewpoint
of the process delivery air measured after
the desiccant wheel and before the process
heater. The dewpoint control will automat-
ically adjust the regeneration temperature
to maintain the dewpoint setpoint.
Dewpoint control is not active with -40
°F
{-40°C} setpoint. See screen 24, page
4-15 for information about using the
dewpoint control or monitor.
NOTE: Dewpoint actual will not be live for
approximately 5 to 8 minutes.
This is the dryer MAIN MENU. It can be
located by pressing the “MENU” key
while at the DEFAULT screen. By press-
ing the Select Category buttons under the
titles, the user goes to STATUS screens,
SETUP screens, or DIAGNOSTIC
screens.
Function
4-12 l Operation
Control Function Descriptions(continued)
✐
PROCESS DEWPOINT
ACT -47°F SET -40°F
DRYER MAIN MENU
STAT SETUP DIAG