User guide

3-20 l Installation
Using Communications
The DeviceNet cable feature is a standard feature on W600-5000 dryers with
DC-2 controls. It allows the dryer to be connected your communications network.
If the communications feature will NOT be used for your
application, simply coil the cable to keep it out of the way.
If the communications feature IS to be used for your
application, please refer to the documentation supplied in
the Communication Addendum of this manual.
To use the optional SPI, Modbus, Ethernet or standard
DeviceNet communications see the Addendum for
hardware installation and configuration.
DeviceNet Connection
SPI Connection
Ethernet Connection
Testing the Installation
4 Press the STOP button.
If everything is installed correctly:
• The blowers will continue running as needed to cool the heaters.
(until regeneration heaters are less than 150°F {66°C})
5 The test is over. If the dryer performed the normal operating sequences as out-
lined, you can load the hopper and begin operation. If it did not, refer to the
Troubleshooting section of the User Guide.
Stop