User guide

Testing the Installation
You have completed the installation. Now it’s time to make sure everything works.
1 Make sure there is no material in the hopper. If you have mounted a loader or
vacuum receiver on the hopper, disconnect the material inlet hose at the source.
2 Turn on the main power to the dryer. Make sure the dryer’s disconnect dial
is in the ON position. This powers up the control and the display lights will
illuminate.
3 Press the START button.
If everything is installed correctly:
• The green light on the start button will illuminate.
• The regeneration and process blowers turn on and LEDs will illuminate.
• The regeneration heater turns on and LED will illuminate.
• The desiccant wheel starts turning
1
2
3
4
5
6
7
8
9
Clear
0
Enter
Adjust Setpoint
Acknowledge
Alarm
Start
Stop
Select
Category
Menu
Scroll List
Prev
Next
Auto Start
Dewpoint Control
Process Blower Regen. Blower
Regen. Heater
1000
3
3
Start
Mounting a Loader on the Hopper
If you have a Conair loader or vacuum receiver, you can
use the flange and mounting clips provided on the top of
the hopper. Refer to the manuals that came with your
receiver or loader for detailed installation instructions.
Installation l 3-19
3
Installation