User guide

Connecting the Air Hoses to a
Single Hopper (W600 - 1000)
Using the two flexible hoses provided, connect the inlet of the HTC and outlet
of the drying hopper to the dryer. Make sure the dryer is located as close as
possible to the hopper (approximately 10 ft {3.05 m}).
1 Attach one hose from the return
air inlet, located on top of the
dryer, to the outlet of the hopper.
2 Attach one hose from the delivery
air outlet to the inlet of the HTC.
3 Secure hoses with clamps. The hose clamp should be secured at least 1/4
in. {0.64 cm} from the end of the inlet or outlet tube.
3-12 l Installation
NOTE: Do not allow the
flexible hoses to kink or
crimp.
✐
Return Air
Inlet Adapter
Dry Delivery Air
✐
NOTE: Models W600-1000 dryer aftercooler and dry air delivery configuration shown.
Location on larger models are different. Refer to the labeling on your dryer.