User guide

3-4 l Installation
✒
Positioning the Dryer on the Floor
1 Lift the dryer from the shipping container using a fork truck.
2 Position the dryer on the floor near the hopper or ResinWorks sled. Make
sure the location allows for the connection of all hoses, keeping hose lengths as
short as possible.
Removing the Cable Tie from the
Desiccant Wheel
(W600-1000 models)
1 Open the dryer side panels and remove the cable tie securing the desiccant
wheel, if it was not done while unpacking the dryer.
Installing the Regeneration
Exhaust Cover
The Carousel Plus W Series Dryer’s regeneration exhaust cover must be installed.
To install the regeneration exhaust cover:
1 Remove the exhaust cover that is attached to the dryer’s shipping pallet.
2 Locate the bolt pattern at the top of the dryer, on top of the regeneration
exhaust outlet.
3 Position the regeneration exhaust cover on top of the regeneration exhaust
outlet, aligning both bolt patterns.
4 Secure the regeneration exhaust cover with supplied hardware, using an
appropriately sized wrench.
Desiccant Cable Tie
Regeneration
Exhaust Cover