User guide

2-8 l Description
Carousel Plus W Series
Dehumidifying Dryer Options
• Volatile trap (only in conjunction with aftercooler/intercooler) - The volatile
trap is recommended if drying materials that produce volatile that condense into
a waxy or oily residue and/or if the material contains excessive fines.
• Precooler - The precooler reduces the temperature of air after the desiccant
wheel and before the process heater, which enables the dryer to control
temperatures at low setpoints, (100º - 150ºF {38º - 66ºC})
• Filter check - The filter check sensor will activate a passive alarm when the
process filter is clogged or needs to be replaced.
• CFM monitor - The CFM monitor measures the cubic feet per minute of air
flow across the inlet/outlet of the process blower.
• Communications - Allows the dryer to be networked to industrial control
systems. DeviceNet is standard. Modbus, SPI and Ethernet are available.
• Heater current monitor - The heater current monitor measures the total
amperage across both the process and regeneration heaters and the
pre-determined power consumption values for the blowers and the control.
NOTE: Temperature setback is only available in conjunction with the Hopper Temperature
Controller (HTC) or the ResinWorks system.
✐
NOTE: The Drying Monitor 2 (DM-II) is for use with single hopper applications, it is not
applicable on ResinWorks systems.
✐