User guide

Replacing the Regeneration Heater

(W600 - 1000)

1 Stop the dryer, disconnect the power, and follow proper lockout

procedures.

2 Remove the right side panel of the dryer, as viewed from the

front of the dryer, to gain access to the regeneration heater.

3 Disconnect the regeneration heater power wires from the terminal

block in the control cabinet. Feed the regeneration power cable out of the

control cabinet.

4 Unplug the quick disconnect for the

high temperature switch cable at the

switch.

5 Loosen the hose clamps then remove

the hoses from the top and bottom of

the regeneration heater tube. Remove

and check the bottom heater hose for

loose debris or fragments, these frag-

ments can damage the newly installed

heater if not removed.

6 While supporting the heater tube,

loosen the hose clamp supporting the

regeneration tube to the mounting

bracket, then remove the heater tube

from the dryer.

7 Slide the insulation off the heater

tube, or make a cut the entire length of

the insulation sleeve to aid removal.

6-26 l Troubleshooting

IMPORTANT

: Always refer

to the wiring diagrams

that came with your dryer

to locate specific electri-

cal components.

Illustrations in the User

Guide are intended to be

representative only.

Regeneration

Heater

Insulation

Clamp