Technical information

Installation

Figure 50: DX-490CB through DX-4120CB with Connectors

Mechanical Installation - Motor

To provide proper mechanical alignment, the mounting surface of the motor face plate is held

perpendicular to the motor shaft to within 0.005 inches. A close tolerance circular pilot boss

projects above the plane of the mounting surface. Matching the pilot boss with a pilot hole in

the mounting structure facilitates interchanging the motor and minimizes the need for

mechanical adjustments. The mounting surface is fitted with four equally spaced holes on a

bolt circle pattern.

The mounting surface must be stiff enough so it does not deflect when radial loads are applied

to the motor shaft. The mounting surface should also have good thermal conductivity,

especially if peak performance is demanded of the motor.

Failure to follow safe installation guidelines can cause death or serious injury.

Mechanical shock to the motor case or shaft (e.g., from striking or dropping) must be

avoided to prevent damage to the motor. Possible results from striking or dropping

include: misalignment of the resolver, damage to stator bearings, cracking of the motor

case and unbonding or demagnetization of the permanent magnets. Any of these will

render the motor unserviceable.

USER SUPPLIED

DC VOLTAGE SOURCE

DX MOTOR

BRAKE

FX DRIVE

HN/C

BRAKE +

DGND

ESHLD

BRAKE -

BRAKE SHLD

RED

BLK

BLU

GRN

BLU/WHT

ECL-XXX CABLE

INTERNAL TO

MOTOR