Technical information

viii
Example Reference Manual
Figure 1: External Disconnect Example (FX-6200 through FX-4800)
Failure to follow safe installation guidelines can cause death or serious injury.
For FX-6200 through FX-8400 models only:
You must wait at least one second after the application of bridge AC power before
sending any type of motion command to allow the Soft Start Cycle to be completed.
Failure to do so will result in damage to the drive.
Safety Precautions
This product is intended for professional incorporation into a complete system. If you install
the product incorrectly, it may present a safety hazard. The product and system may use high
voltages and currents, carries a high level of stored electrical energy, or is used to control
mechanical equipment which can cause injury.
You should give close attention to the electrical installation and system design to avoid
hazards either in normal operation or in the event of equipment malfunction. System design,
installation, commissioning and maintenance must be carried out by personnel who have the
necessary training and experience. Read and follow this safety information and the instruction
manual carefully.
Enclosure
This product is intended to be mounted in an enclosure which prevents access except by
trained and authorized personnel, and which prevents the ingress of contamination. This
product is designed for use in an environment classified as pollution degree 2 in accordance
with IEC664-1. This means that only dry, non-conducting contamination is acceptable.
THREE PHASE
196-264 VAC
50/60 Hz
GND
L1
L2
L3
L1
L2
L1
L2
L1
L3
L2
AC POWER
INPUT
AUX AC
POWER
INPUT
FX DRIVE
SINGLE PHASE
196-264 VAC