Technical information

Verify there is material in the hopper.

Turn on main power to the dryer.

◆ The white power light turns on.

◆ Temperature display turns on.

◆ Temperature controller performs

self-diagnostic testing.

Set the drying temperature.

Press the up or down arrow on the tem-

perature controller until the setpoint tem-

perature you want appears in the lower

display.

Flip the toggle switch to START.

◆ The green drying light turns on.

◆ Both blowers turn on.

◆ Heaters turn on.

◆ If the desiccant tanks aren’t in their correct position,

the carousel will turn to the correct position.

◆ The yellow air flow alarm light will turn on each

time the desiccant carousel indexes correctly.

Flip the toggle switch to STOP.

◆ The drying light stays on and the

blowers continue running for two

minutes to cool the heaters.

OPERATION 4-3

UGD001/1196 SC Carousel Dehumidifying Dryer

TO START

DRYING

NOTE: The drying light will not turn on if the

Emergency Stop button is pushed in. Make sure the

stop button is pulled out before starting the dryer.

188

SET TEMPERATURE

STOP

START

TO STOP

DRYING

STOP

START

IMPORTANT: Do not use the Emergency Stop

button to stop the dryer unless it is an emergency.

Using the Emergency Stop button during normal

operation prevents cooling of the heaters and could

damage your dryer. Using the Emergency Stop but-

ton to stop the dryer also can trigger the Shut

Down/High Temperature alarm during your next dry-

ing cycle.