Technical information

The SC carousel dryer comes in one to four boxes, depending
on the models and options ordered. The boxes should include:
Carefully remove the dryer and components
from their shipping containers, and set upright.
Remove all packing material, protective paper, tape
and plastic.
Carefully inspect all components to make sure no
damage occurred during shipping, and that you have all
the necessary hardware.
T
ake a moment to record serial numbers and
electrical power specifications in the blanks provided on
the back of the the User Guide’s title page. The informa-
tion will be helpful if you ever need service or parts.
You are now ready to begin installation.
Follow the preparation steps on the next page, then
choose one of the three mounting options:
● Dryer and hopper on a mobile floor stand. (Go to
page 3-8 after completing first preparation step.)
● Dryer and hopper on the processing machine throat.
● Dryer on a floor stand; hopper on the throat.
INSTALLATION
3-2
SC Carousel Dehumidifying Dryer UGD001/1196
180
180
1
2
3
4
Drying
hopper
Mounting
adapter
(optional)
Discharge
assembly
(small or large)
Dryer/hopper
Support frame
(optional)
Two lengths of
flexible hose
(one insulated)
Floor stand
(optional)
Hopper
slide gate
SC Dryer
Mounting Hardware:
Floor stand option:
❒ four 3/8-16 self-locking bolts
❒ four 3/8-16 bolts with lock
washers
❒ three 1/4-20 self-locking bolts
❒ four hose clamps
Support frame option:
❒ eight 3/8-16 self-locking bolts
❒ three 1/4-20 self-locking bolts
❒ four 3/8-16 countersunk bolts
❒ four hose clamps
NOTE: You must mount the
dryer on a floor stand, If
your processing machine
throat opening is 1 inch
(2.54 cm) diameter or
smaller and requires a
3x3 inch (7.6x7.6 cm) or
smaller bolt pattern.
Hopper
base plate
5
RTD probe
UNPACKING
THE BOXES