Instructions / Assembly

Grip Prints™
Instructions for Use
1) Prepare Surface
• Apply only to clean, smooth
surface. To clean, use soap &
water. Rinse & dry thoroughly.
• Products may not adhere to fabric,
rough or pebbly surfaces or
surfaces under 55˚F (13˚ C).
2) Measure & Cut
• Allow at least 3/8” (1cm) overlap
on all edges for possible shrinkage.
3) Apply
• Beginning at the center, press out
towards edge using squeegee,
straight edge tool or cloth.
• Covering may be lifted and
repositioned during application to
eliminate bubbles or wrinkles.
• Avoid pulling or stretching.