Datasheet

NOTES
When cutting or bending switch leads it is important that the glass
seal is not damaged. The cutting or bending point should be no
closer than 3mm (.118in.) to the glass to metal seal and the lead
should be supported between the cutting or bending point and the
glass to metal sea
l.
We offer a crop and form service for Reed Switches to be
customized to your specification.
DIMENSIONS

=?
Z
=Z?

=?

=?
PICTURE
Drawings not to scale
All dimensions in mm [inches] nominal.
ORDERING INFORMATION
PART NUMBER GC 1623 80 120
Type
Minimum Sensitivity (AT)
Maximum Sensitivity (AT)
Example:
Type 1623, Pull-in sensitivity between 80 - 120AT
is PART NO: 1623 80 120
REV. NO. REVISION NOTE DATE SIGNATURE
2 Datasheet Redesign 29-03-07 LG
Part Number :
GC 1623
GC 1623 - Product Data Sheet
Reed Switch - Break Before Make Contact Form
SPECIFICATIONS
Contact Form C (Break Before Make)
Contact Material Rhodium
Switching Capacity Max. 60/80 W/VA
Switching Voltage Max. 230 VAC/DC
Switching Current Max. 2.0 A
Carrying Current Max. 3.0 A
Dielectric Strength Min. 400 VDC
Contact Resistance Max. 100 mOhms
Insulation Resistance Min. 10
9
Ohms
Pull - In - Sensitivity 80 - 120 AT
Drop - Out - Sensitivity
Min.
20 AT
Switching Time Without Bounce Max. 4.0 ms
Bounce Time
Max.
0.5 ms
Release Time
Max.
0.1 ms
Resonance Frequency
Typ.
-
Operating Frequency
Max.
100 Hz
Vibration 10 -500 35 Hz
Shock 11 ms 50 g
Capacitance
Typ.
1.0 pF
Operating Temperature Range
Deg
-40 + 125°C
Test Coil
Type
1500
TAKE A LOOK AT OUR VARIETY OF PRODUCTS
Float Switches Acceleration /
Shock Switches
Movement
Sensors
Tilt / Tip Switches Reed Relays Solid State
Relays
High Breakdown
Switches
Reed Switches
Magnets
Electronic Tilt /
Tip Over
Low Cost - Non
Mercury Switches
Rubber Keymats -
Silicone Rubber
As part of the company policy of continued product improvement, specifications may change without notice. Our sales office will be pleased
to help you with the latest information on this product range and the details of our full design and manufacturing service. All products are
supplied to our standard conditions of sale unless otherwise agreed in writing.
Phone: [phone] www.comus-intl.com Fax : [phone]
Assemtech, UK: [phone] - Belgium: + 32 (0)12 390400 - France: + 33 (0) 1 43 96 86 10
©2007 Copyright Comus International ,454 Alwood Road, Clifton NJ 07012, USA.