User Manual

22000484Rev.E DeviceMasterUPPROFINETIOInstallationQuickStart
DataTypeDefinitions
7. InstalltheGSDMLfileinHW Config.IntheHW Configwindow,selectInstall GSDfromtheOptionspull‐down
menu.ChoosethedirectorywhereyouinstalledthePROFINETIOsoftwareinStep4.
8. C
ONNECTanyserialdeviceordevices.
9. VerifyanyEthernetTCP/IPdevicesareconnectedasconfiguredintheDeviceMasterUP.
DataTypeDefinitions
Thefollowingdatatypedefinitionsapply.
ConfiguringReadOnlySerialDevices
Usethefollowingproceduretoconfigureread‐onlyserialports.
Note: Make sure that you have performed Steps 1 through
5 in the Installation Overview on Page 1.
1. AccesstheServerConfigurationwebpageusingoneofthefollowingmethods:
• EnteringtheIPaddressinyourwebbrowser
• Right‐clicktheDeviceMasterUPinPortVisionDXandclickWeb Manager
2. ClickSerialDeviceConfiguration.
3. ClickthePort#thatyouwanttoconfigure,whichopenstheEditSerialPortConfigurationpage.
DataType Definition
BYTE Aninteger0‐255(8‐bit)e.g.ASCIIstringsareaseriesofbytes
WORD Unsignedinteger(16‐bit)
DWORD Unsignedinteger(32‐bit)