Manual

Driver and Adapter Information 13
Driver Installation
Note: If you are installing more than one adapter, install all PCI-bus adapters
before installing any ISA-bus adapters.
13. If you have installed a RocketPort adapter that is capable of speeds over 230.4K
bps, you can configure the driver for high-speed operation at this time. Follow
these steps:
a. Select the Options tab.
b. Use the Scan Rate droplist to select a driver servicing rate. For example, to
use an Octacable at 460.8K bps, select 4. To use a RocketPort Plus at
921.6K bps, select 2 or 1.
For more information about the Options tab and Scan Rate control, see
Changing or Viewing Driver Configuration
.
c. Select the Main Setup tab. The Device Setup tab reappears.
14. Select the OK button to close the Setup window.
15. Select the Ye s button when the confirmation window appears, asking you to
verify that you want to save the configuration and exit. The setup process
creates and displays the program group:
16. Select the OK button when this reminder appears.
17. Select the Close button when the Network Adapters window appears, showing
the Comtrol adapter.
18. Select the Ye s button to shut down and restart the server, or the No button to
put it off until a more convenient time.
Note: You must shut down and restart the server before your changes take
effect. Do not use the Comtrol Setup program until you have done so.