Manual

DeviceMaster Modbus Server User Guide: 2000535 Rev. C Embedded Web Pages - 25
Embedded Web Pages
All configuration and status information is provided through embedded web pages
for Modbus Server.
Note: T
he latest Modbus Server firmware must be installed before you can
configure network or serial/socket port characteristics.
For firmware installation and setup information, see
Installation Overview on
Page 11 or the PortVision DX help system.
This section discusses the following:
• Configuration overview (below)
• Server Configuration (Main) Page
on Page 26
• Serial Interface Configuration Page
on Page 27
• Edit Port Configuration Page
on Page 28
• Edit Network Configuration Page
on Page 31
See the Embedded Diagnostic and Statistics Pages (Page 33) section for
information about locating diagnostic and
statistics for Modbus Server.
Configuration Overview
The following overview shows how to access the DeviceMaster Server
Configuration embedded web page and configure serial device interfaces.
Note: If you have not configured the network information into the DeviceMaster
during initial setup, you must configure the network information before
configuring port characteristics.
1. From PortVision DX, highlight the
DeviceMaster that you want to configure
and select Webpage.
2. Optionally, enter the IP address of the
device in the Address box of your web
browse.
3. Select Serial Interface Configuration.
4. Select the appropriate port to access the
Edit Port Configuration page for that port.
5. Change the serial port configuration
properties as required for your site.