User Manual

46 - Initial Configuration DeviceMaster Installation and Configuration Guide: 2000594 Rev. A
Uploading SocketServer with PortVision DX
4. Click Ye s to the Upload Firmware message that warns you that this is a
sensitive process. It may take a few moments for the firmware to upload onto
the DeviceMaster. The DeviceMaster reboots itself during the upload process.
5. Click Ok to the advisory message about waiting to use the device until the
status reads ON-LINE. In the next polling cycle, PortVision DX updates the
Device List pane and displays the new SocketServer version or right-click the
DeviceMaster and click Refresh.
6. If the upload fails, reset the Bootloader timeout to 60 seconds and then repeat
Steps 3
through 5. For procedures, see Changing the Bootloader Timeout on
Page 115.
You are now ready to continue the installation and configuration process.
• Device Driver (NS-Link) Installation
on Page 51
• Socket Port Configuration
on Page 65