User Manual

DeviceMaster Installation and Configuration Guide: 2000594 Rev. A Hardware Installation - 19

Hardware Installation

Mounting the

Embedded

Use the following procedure to mount the DeviceMaster 1-Port Embedded with the

5-30VDC power supply.

Observe proper ESD techniques when handling the DeviceMaster.

1. Carefully remove the DeviceMaster from the anti-static bag, following

standard electrostatic device handling procedures.

Note: Write down the MAC address located on a label on the bottom (solder

side) center of the DeviceMaster because you may need it during

configuration.

2. Mount the DeviceMaster for your environment using 1/4” stand-offs to

separate the DeviceMaster from the base.

3. Use one of the following methods to ground the DeviceMaster.

• Through the power supply by connecting the ground wire on the power

cable using plastic or metal stand-offs.

• Through the chassis, using metal stand-offs. If plastic stand-offs are used

to mount the board, then you must ground the DeviceMaster using the

power cable.

Note: The maximum diameter of the metal stand-offs should be 0.175” with a

4-40 machine screw. Metal stand-offs are not provided with the

DeviceMaster.

Caution

Non‐plated/non‐groundedmountingholes0.116”diameter(+/‐0.003”).

WARNING:Holesinhatchedareaarenotmountingholes.

Maximumcomponentheightaboveboardis0.55”.

EthernetconnectionJ2:J2overhangsboardedgeby0.14”andtheheightis0.55”.



LEDlightpipemountingholes.TheLEDlightpipesarenotprovided.

SerialportconnectorJ3:0.1”pinspacing,0.025”squarepindiameter,and0.230”

pinheight.

DebugportconnectorJ4:0.1”pinspacing,0.025”squarepindiameter,and0.230”

Powerconnector;thematingconnectorisWeidmullerP/N:152651.

Plated/chassisgroundedmountinghole0.116”diameter(+/‐0.003”).

pinheight.

5-30VDC Model



Caution