Specifications

Page 8 of 8
9/25/2013 1:47 PM
AC2000 Data Sheets, Version 6.30
Job Order:
13331
Revision:
C
Data Sheets
Air Handling Unit Information
Sales Order:
130079-01
Dwg. No.:
E-13331-1
8.
4.
5.
BAH to make sure the unit nameplate contains the following information:
a) TEI Document Number: TCS41704A
b) TEI Air Handling System Serial No: AHU 00407
c) Buffalo Air Handling Serial No: 130079-01
6.
BAH to complete an Inspection/Testing checkoff sheet provided by Thomas Engineering, Inc. The checkoff sheet is a one page
document. Should any deficiences be found, they are to be recorded on a separate form.
7.
All exposed openings on the air handler are to be sealed shut.
C. 9/6/2013
M.C.
1. ADDED DRIVE INFO.
2. REVISED FAN PERFORMANCE
PER 12983, 12979
A. 6/25/2013
I.J.
1. FILTER NOTE 4 - "GEL" WAS "GASKET".
2. FILTER NOTE 7 - "A-4S" WAS "B-1S".
3. MIXING NOTE 2C - "HGA" WAS "GGA".
4. HUMIDIFIER NOTE 1 - ADDED CONTROL RANGE.
CHG'S PER C.O. #12895
B. 8/26/2013
I.J.
1. UNIT CONSTRUCTION NOTE 7 - ADDED.
2. V-BELT DRIVE NOTE 2 - ADDED.
3. FAN NOTE 2 - ADDED.
4. VIBRATION ISOLATION BASE TYPE WAS STRUCTURAL.
5. DELETED HEPA FILTER BANK "B" AND FRAMES.
6. FILTER NOTES 4-7,10,13 - DELETED.
7. FILTER NOTE 9 - CONNECTION VOLTAGE WAS 120VAC.
8. UNIT CONSTRUCTION NOTE 1 - DELETED "CONTINUOUSLY WELD .......".
9. UNIT CONSTRUCTION NOTE 2 - DELETED.
10. ADDED DAMPER OPERATOR TYPES (TWO POSITION OR MODULATING).
11. MISC. NOTE 3G - WAS SUPPLY AIR PRE/INTERMEDIATE FILTER GAUGE - PDIS 200.
12. MISC. NOTE 3R - WAS SUPPLY AIR PRE/INTERMEDIATE FILTER GAUGE - PDIS 220.
13. DRAIN PAN CONNECTION HAND WAS LEFT HAND.
14. HUMIDIFIER NOTE 3 - ADDED.
CHG'S PER C.O. #12965
15. DESICCANT DEHUMIDIFIER NOTE 2A - "REMOTELY MOUNTED" WAS "FACTORY WIRED".
16. FILTER NOTE 12 - DELETED.
17. FILTER NOTE 8 - QTY WAS (3).
18. MISC. NOTE 3H - DELETED "HEPA TEST PORT HIGH" AND "HEPA TEST PORT LOW".
19. MISC. NOTE 3P - DELETED.
20. MISC. NOTE 3Q - DELETED.
21. MISC. NOTE 8 - DELETED.
22. DEHUMIDIFIER/FAN SECTION WEIGHT WAS 2,700#.
23. DISCHARGE SECTION WEIGHT WAS 2,100#.
CHG'S PER NEW INFO
REVISIONS
Rev. Date of Change
Init.
Description of Change(s)
9.
Unit to be shipped on a wooden skid. Must use heat treated lumber. Fork lift must be able to pull the skid off of a truck. Skid must
extend beyond the largest item protruding off of the AHU.
Do not ship loose items in a coil section. Customer does not want to risk damaging any coil fins during shipment.