User Manual

Hardware Installation RocketLinx ES7110 and ES7110-VB User Guide: 2000552 Rev. C - 7
Hardware Installation
You can use the following subsections to install the RocketLinx ES7110:
• Setting the DIP Switch
• Connecting the Power on Page 8
• Wiring the Relay Output and Ground
on Page 9
• Mounting the RocketLinx ES7110
on Page 10
• Connecting the Ethernet Ports
on Page 10
• Front Panel and LEDs
on Page 12
Setting the DIP Switch
The ES7110 has a 10-pin DIP switch located on the bottom of the switch to configure the Port Link Alarm for the Ethernet
ports. The following table shows the DIP switch number mapping to the corresponding PoE and Gigabit ports as follows.
Port G2 Port G1 Port 1 Port 2 Port 3 Port 4 Port 5 Port 6 Port 7 Port 8
DIP 1 DIP 2 DIP 3 DIP 4 DIP 5 DIP 6 DIP 7 DIP 8 DIP 9 DIP 10
DIP Switch Number Status Description
1-2
On Enables the Gigabit port link failure alarm for this port.
Off
(Default)
Disables the Gigabit port link failure alarm for this port.
3-10
On
Enables the PoE port link failure alarm for the
corresponding port.
Off
(Default)
Disables the PoE port link failure alarm for the
corresponding port.