Manualshelf

Manual

ManualsBrandsComtrol ManualsAccessories communicationeCos
251252253254255256257258259260
Chapter 5. Installation and Testing
Initial Installation
RedBoot is installed using the code download facility built into the Malta board. See the Malta User manual for
details, and also the Malta download format in the Section called Malta download format.
Quick download instructions
Here are quick start instructions for downloading the prebuilt RedBoot image.
1. Locate the prebuilt files in the bin directory: deleteall.fl and redboot_ROM.fl.
2. Make sure switch S5-1 is ON. Reset the board and verify that the LED display reads Flash DL.
3. Make sure your parallel port is connected to the 1284 port Of the Atlas board.
4. Send the deleteall.fl file to the parallel port to erase previous images:
$ cat deleteall.fl >/dev/lp0
When this is complete, the LED display should read Deleted.
5. Send the RedBoot image to the board:
$ cat redboot_ROM.fl >/dev/lp0
When this is complete, the LED display should show the last address programmed. This will be something
like: 1fc17000.
6. Change switch S5-1 to OFF and reset the board. The LED display should read RedBoot.
7. Run the RedBoot fis init and fconfig commands to initialize the flash. See the Section called Flash Image
System (FIS) in Chapter 2 and the Section called Persistent State Flash-based Configuration and Control in
Chapter 2 for details.
Malta download format
In order to download RedBoot to the Malta board, it must be converted to the Malta download format.
The Atlas/Malta Developer’s Kit CD contains an srecconv.pl utility which requires Perl. This utility is part of
the yamon/yamon-src-02.00.tar.gz tarball on the Dev Kit CD. The path in the expanded tarball is ya-
mon/bin/tools. To use srecconv to convert the S-record file:
$ cp redboot_ROM.srec redboot_ROM.rec
$ srecconv.pl -ES L -A 29 redboot_ROM
The resulting file is named redboot_ROM.fl.
Additional commands
The exec command which allows the loading and execution of Linux kernels, is supported for this architecture (see
the Section called Executing Programs from RedBoot in Chapter 2). The exec parameters used for MIPS boards
are:
148