Manual

82 - Managing the DeviceMaster LT
DeviceMaster LT User Guide: 2000586 Rev. B
Loading Port Configuration
6. Highlight the configuration file and click Open. The configuration file loads in
a few moments.
7. Make the appropriate choice for your situation:
•Click No to
the ComtrolApplet message, if you are using the file to set up
mul
tiple DeviceMaster LTs with the same device-level settings.
•Click Ye
s to the ComtrolApplet message, if you are using the file to restore
a specific DeviceMaster LT. For example, you needed to remove
and then
re-inst
all the DeviceMaster LT NS-Link device driver.
8. Click Ap
ply so that the configuration is saved on the DeviceMaster LT.
9. Go to the next procedure if you want
to restore port settings from a
conf
iguration file.
Loading Port
Conf
iguration
Use the following procedure to load the configuration file for port-level settings for
your DeviceMaster LT.
Note: Device driver configuration files must
be for the same model with the same
port density
1. If necessary, open the C
omtrol Drivers Management Console using one of these
methods:
• Windows Control Panel; go
to your Control Panel and click on the
Comtr
ol Drivers Management Console.
• Shortcut; l
ocated under Start> Program Files> Comtrol> DeviceMaster LT>
Comtrol Drivers Management Console.
2. Depending on your operating system, you may need to click Ye
s to the Do you
wa
nt to allow the following program to make changes to this computer? User
Account Control message.