Manual
DeviceMaster LT User Guide: 2000586 Rev. B
Managing the DeviceMaster LT - 69
Managing the DeviceMaster LT
This section discusses the following DeviceMaster LT maintenance procedures:
• Rebooting the DeviceMaster LT
•
Updating Firmware Across WANs (Windows) on Page 70
•
Uploading SocketServer to Multiple DeviceMaster LTs on Page 74
•
Configuring Multiple DeviceMaster LTs Network Addresses on Page 75
Note: You c
an configure the network addresses for multiple DeviceMaster LTs,
configure com
mon settings for the DeviceMaster LTs, and save the
settings to a configuration file that you can use to load settings up to all
or selected DeviceMaster LTs.
•
Adding a New Device in PortVision DX on Page 75
•
Using SocketServer Configuration Files on Page 77
•
Using Driver Configuration Files on Page 79
•
Changing the Bootloader Timeout on Page 84, which discusses changing the
Bootloader timeout
•
Managing Bootloader on Page 85, which also discusses checking the
Bootloader version and downloading the latest Bootloader
•
Checking the NS-Link Version on Page 87
•
Accessing SocketServer Commands in Telnet/SSH Sessions (PortVision DX)
on Page 90
Note: Y
ou can optionally refer to RedBoot Procedures on Page 99 if you want to
perform procedures at the RedBoot level.
Rebooting the DeviceMaster LT
There are many ways to reboot the DeviceMaster LT.
Optionally, you can power cycle
the DeviceMaster LT.
Method Procedure
PortVision DX
Right-click the DeviceMaster LT or DeviceMaster LTs in the
Device L
ist pane, click Advanced >Reboot and then Ye s.
Note: I
f security has been enabled in the web page, you will
need to reboot the DeviceMaster LT in the web page.
Web page
Main page (Server Status): Scroll
to the bottom of the page,
click Reboot and then Yes : Rebo ot.
Telnet Type re
set.
DeviceMaster LT
DeviceMaster LT has a Reset/Resto
re switch.
•If the Reset/R
estore switch is depressed for less than 2
seconds, the DeviceMaster LT reboots.
•If the Reset/R
estore switch is depressed for greater than
approximately 5 seconds it restores the DeviceMaster LT
to the factory default values.