Specifications

87

 2.7.1.3Setupprocedurefor‘APBridgePointtoPoint’:

Inthismode,youcanconnectyourwirelessrouterwithanother,to

combinetwoaccesspointsandexpandthescopeofthewireless

network,andallclients(wiredonly–APwillnotacceptwirelessclients

inthismode)ofthetwowirelessrouterswillthinkthey’reonthesame

physicalnetwork.Thisfunctio

nisveryconvenientwhenyouneedto

connecttwonetworksbetweentwobuildings.

SelectAPBridge(PointtoPoint) fromthe‘Mode’drop‐downmenu(1),

andthefollowingwillbedisplayed:



Herearedescriptionsofeverysetupitem:

Band(2):Selectthebandyouwanttouse,thetwowireless

routersmustusethesamesetting.

ChannelSelectthechannelyouwanttouse,thetwo

Number(3): wirelessroutersmustusethesamesetting.

MAC

address1(4): InputtheMACaddressofanotherwirelessrouter.

Security

  Clickthe‘SecuritySettings’buttonforthis

Settings(5):connection.

 (Gotosection‘2‐7‐3WirelessSecurity’

fordetailedinstructions).

NOTE: The two wireless routers must use the same mode, band, channel

number, and security setting!