User manual

Enter STA PIN: a Personal Identification Number (PIN) has to be read from either

a sticker or the display on the new wireless device. This PIN must then be inputted

at representing the network, usually the Access Point of the network.

B - For Unconfigured mode, click the Config AP button.

Step 7: Activate the PIN function on the wireless client. For Configured mode,

the client must be configured as an Enrollee. For Unconfigured mode,

the client must be configured as the Registrar. This is different from the

External Registrar function provided in Windows Vista.

The figure below provides an example of a WPS client PIN function in-progress.

Now go to Step 8 (part IV. Check Connection) to check the WPS connection.

IV. CHECK CONNECTION

Step 8: If the WPS setup method was successful, you will be able access the

wireless AP from the client. The client software should show the status.

The example below shows that the connection established successfully.

You can also double-click the Wireless Network Connection icon from the

Network Connections window (or the system tray) to confirm the status of

the new connection.