User manual

80
The CPE deco server is running on "Default". And ISP's deco server is running on
PVC 0/36. It is for set-top box use only.
On the LAN side, the PC can get IP address from CPE deco server and access the
Internet via PPPoE (0/33).
If the set-top box was connected with interface "ENET1" and send a deco request
with vendor id "Video", the CPE deco server would forward this request to ISP's deco
server. Then the CPE will change the PortMapping configuration automatically.
The Port Mapping configuration will become:
1. Default: ENET2, ENET3, ENET4, Wireless and USB.
2. Video: nas_0_36, nas_0_37, nas_0_38 and ENET1.
6.11 IPSec
You can add, edit or remove IPSec tunnel mode connections from this page.
By clicking Add New Connection, you can add a new IPSec termination rule.
The following screen will display.