User manual

4.2.3 IP Over ATM

Step 4: Select the IP over ATM (IPoA) radio button and click Next.

NOTE: DHCP is not supported over IPoA. The user must enter the IP address or

WAN interface for the default gateway setup and the DNS server

addresses provided by their ISP.

Step 5: Click Next. The following screen appears.

Enable NAT checkbox: If the LAN is configured with a private IP address, the user

should select this checkbox. The NAT submenu on the left side main panel will be

displayed after reboot. The user can then configure NAT-related features. If a

private IP address is not used on the LAN side (i.e. the LAN side is using a public IP),

this checkbox should not be selected. When the system comes back after reboot,

the NAT submenu will not be displayed on the left main panel.