User manual

This screen allows the user to configure the LAN interface IP address, subnet mask

and DHCP server. To assign dynamic IP address, DNS server and default gateway

to other LAN devices, select Enable DHCP server and enter the start and end IP

addresses and DHCP leased time.

Since the router occupies the first two IP addresses (192.168.1.1 and 192.168.1.2),

the default private address range provided by the ISP server in the router is

192.168.1.3 through 192.168.1.254.

Select Enable DHCP Server Relay (if available, see note below), and enter the

DHCP Server IP Address. This allows the router to relay the DHCP packets from the

remote DHCP server. The remote DHCP server will provide the IP address.

NOTE: If the NAT function is enabled (default), Enable DHCP Server Relay

won’t be displayed as an option.

To configure a secondary IP address for the LAN port, click the box as shown below.

Step 7: Click Next to continue. To enable the wireless function, select the radio

button (as shown), input a new SSID (if desired).

Click Next to display the final setup screen.