User`s manual

The screen creates a traffic class rule to classify the upstream traffic, assign queuing

priority and optionally overwrite the IP header TOS byte. A rule consists of a class

name and at least one condition below. All of the specified conditions in this

classification rule must be satisfied for the rule to take effect. Click 'Save/Apply' to

save and activate the rule.

Traffic Class Name Enter name for traffic class.

Assign ATM Transmit Priority Select Low, Medium or High.

Mark IP Precedence Select between 0-7. The lower the digit shows the

higher the priority

If non-blank value is selected for 'Mark IP

Precedence' and/or 'Mark IP Type Of Service', the

corresponding TOS byte in the IP header of the

upstream packet is overwritten by the selected

value.

Note: If Differentiated Service Configuration

checkbox is selected, you will only need to assign

ATM priority. IP Precedence will not be used for

classification. IP TOS byte will be used for DSCP

mark.

Mark IP Type Of Service Select either: Normal Service, Minimize Cost,

Maximize Reliability, Maximize Throughput,

Minimize Delay

If non-blank value is selected for 'Mark IP

Precedence' and/or 'Mark IP Type Of Service', the

corresponding TOS byte in the IP header of the

upstream packet is overwritten by the selected

value.

Note: If Differentiated Service Configuration

checkbox is selected, you will only need to assign

ATM priority. IP Precedence will not be used for

classification. IP TOS byte will be used for DSCP

mark.

Mark 802.1p if 802.1q is

enabled on WAN

Select between 0-7.

Specify Traffic Classification Rules

Enter the following conditions either for physical LAN/Wireless port or for IP level,

SET-1, or for IEEE 802.1p, SET-2