User`s manual

Chapter 3 Web User Interface

This section describes how to access the device via the web user interface using

an Internet browser such as Microsoft Internet Explorer (version 5.0 and later).

3.1 Default Settings

The following are the default settings for the device.

• Local (LAN access) Username: root , Password: 12345

• Remote (WAN access) Username: support, Password: support

• LAN port IP address: 192.168.1.1

• Remote WAN access: disabled

• NAT and firewall: enabled

• DHCP server on LAN interface: enabled

• WAN IP address: none

Technical Note:

During power on, the device initializes all settings to default values. It will then

read the configuration profile from the permanent storage section of flash

memory. The default attributes are overwritten when identical attributes with

different values are configured. The configuration profile in permanent storage

can be created via the web user interface or telnet user interface, or other

management protocols. The factory default configuration can be restored either

by pushing the reset button for more than five seconds until the power indicates

LED blinking or by clicking the Restore Default Configuration option in the Restore

Settings screen.