User`s manual

67
9.1.3 Restore Default
Select Restore Default from the Settings submenu to access the screen shown
below. Click the Restore Default Settings button to restore the device to the
default firmware settings. Restoring system settings require a device reboot.
The default settings can be found in section 3.1 Default Settings.
After the Restore Default Configuration button is selected, the following screen
appears. Close the device Configuration window and wait for 2 minutes before
reopening your web browser. If necessary, reconfigure your PC's IP address to
match your new configuration.
After a successful reboot, the browser will return to the Device Info screen. If
the browser does not refresh to the default page, close and restart the browser.
NOTE: The Restore Default function has the same effect as the reset button.
The device board hardware and the boot loader support the reset to
default button. If the reset button is continuously pushed for more
than 5 seconds (and not more than 12 seconds), the boot loader will
erase the configuration settings saved on flash memory.