User manual

52
Field
Description
SET-1
Protocol
TCP, TCP/UDP, UDP, or ICMP.
Differentiated
Services Code Point
(DSCP) Check
The selected Code Point gives the corresponding priority to
the packets that satisfies the rules set below.
Static IP or DHCP ID
drop-down box
Select IP Address, Vendor Class ID (DHCP Option 60), or
User Class ID (DHCP Option 77)
Source IP Address
Enter the source IP address.
Source Subnet Mask
Enter the subnet mask for the source IP address.
UDP/TCP Source Port
(port or port:port)
Enter source port number or port range.
Destination IP
address
Enter destination IP address.
Destination Subnet
Mask
Enter destination subnet mask.
UDP/TCP Destination
Port (port or
port:port)
Enter destination port number or port range.
Source MAC Address
A packet belongs to SET-1, if a binary-AND of its source MAC
address with the Source MAC Mask is equal to the
binary-AND of the Source MAC Mask and this field.
Source MAC Mask
This is the mask used to decide how many bits are checked
in Source MAC Address.
Destination MAC
Address
A packet belongs to SET-1 then the result that the
Destination MAC Address of its header binary-AND to the
Destination MAC Mask must equal to the result that this field
binary-AND to the Destination MAC Mask.
Destination MAC
Mask
This is the mask used to decide how many bits are checked
in Destination MAC Address.
SET-2
802.1p Priority
Select between 0-7. The lower the digit shows the higher
the priority
6.7 Routing
This option allows for Default Gateway, Static Route, and RIP configuration.
NOTE: In bridge mode, the RIP screen is hidden while the Default Gateway
and Static Route configuration screens are shown but ineffective.