User manual

DHCP Server: To enable DHCP, select Enable DHCP server and enter Start

and End IP addresses and the Leased Time. This setting

configures the router to automatically assign IP, default

gateway and DNS server addresses to every PC on your LAN.

DHCP Server Relay: Enable with checkbox  and enter DHCP Server IP address.

This allows the Router to relay the DHCP packets to the

remote DHCP server. The remote DHCP server will provide

the IP address. This option is hidden if NAT is enabled or

when the router is configured with only one Bridge PVC.

To configure a secondary IP address, tick the checkbox  outlined (in RED) below.

IP Address: Enter the secondary IP address for the LAN port.

Subnet Mask: Enter the secondary subnet mask for the LAN port.

NOTE: The Save button simply saves changes, while the Save/Reboot button

both saves and reboots the device to make any changes effective.