User`s manual

Option Description
Log Indicates whether the system is currently recording events. The user can
enable or disable event logging. By default, it is disabled. To enable it,
click Enable and then Apply button.
Log
level
Allows you to configure the event level and filter out unwanted events below
this level. The events ranging from the highest critical level “Emergency”
down to this configured level will be recorded to the log buffer on the
CT-6382T SDRAM. When the log buffer is full, the newer event will wrap up
to the top of the log buffer and overwrite the old event. By default, the log
level is “Debugging,” which is the lowest critical level. The following log
levels are
 Emergency = system is unstable
 Alert = action must be taken immediately
 Critical = critical conditions
 Error = Error conditions
 Warning = normal but significant condition
 Notice
 Informational
 Debugging = debug-level messages
Emergency is the most serious event level, whereas Debugging is the least
important. For instance, if the log level is set to Debugging, all the events
from the lowest Debugging level to the most critical level Emergency level
will be recorded. If the log level is set to Error, only Error and the level
above will be logged.
Display
Level
Allows the user to select the logged events and displays on the View
System Log page for events of this level and above to the highest
Emergency level.
Mode Allows you to specify whether events should be stored in the local memory,
or be sent to a remote syslog server, or both simultaneously.
If remote mode is selected, view system log will not be able to display
events saved in the remote syslog server.
When either Remote mode or Both mode is configured, the WEB UI will
prompt the user to enter the Server IP address and Server UDP port.
3. Click View System Log. The results are displayed as follows.
110