User`s manual

Traffic Class Name Enter name for traffic class.
Assign ATM Transmit Priority Select Low, Medium or High.
Mark IP Precedence Select between 0-7. The lower the digit
shows the higher the priority.
Mark IP Type Of Service Select either: Normal Service, Minimize
Cost, Maximize Reliability, Maximize
Throughput, Minimize Delay
Mark 802.1p if 802.1q is enabled on WAN Select between 0-7. The higher the
digit shows the higher the priority.
SET-1
Physical LAN Port Select between ENET(1-4), USB,
Wireless and Wireless_Guest.
Protocol User can select from: TCP, TCP/UDP,
UDP or ICMP.
Source IP Address Enter the source IP address.
Source Subnet Mask Enter the subnet mask for the source IP
address.
Source Port (port or port:port) Enter source port number or port
range.
Destination IP address Enter destination IP address.
Destination Subnet Mask Enter destination subnet mask.
Destination port (port or port:port) Enter destination port number or port
range.
SET-2
802.1p Priority Select between 0-7. The lower the digit
shows the higher the priority
71