User manual

In the LAN side, PC can get IP address from CPE's dhcp server and access

Internet via PPPoE (0/33).

If the setup-box was connected with interface "ENET1" and send a dhcp request

with vendor id "Video", CPE's dhcp server will forward this request to ISP's dhcp

server.

And CPE will change the port mapping configuration automatically. The

portmapping configuration will become:

1. Default : ENET2, ENET3, and ENET4.

2. Video: nas_0_36, nas_0_37, nas_0_38 and ENET1.

7.10 Ping

This screen performs the same function as the console command of the same

name. It allows you to check the connection between the router and any

location on the LAN or WAN. Enter the IP address of the location you wish to

check and click Ping. The router will “ping” the IP address four times, as shown

in the figure below.

NOTE: In the example above, all four data packets were transmitted

successfully, resulting in 0% packet loss. This indicates a good

connection. By comparison, a poor connection will have some packet

loss and no connection will result in 100% packet loss.

- -