User manual

Destination Subnet Mask Enter destination subnet mask.
Destination port (port or
port:port)
Enter destination port number.
SET-2
802.1p Priority Select between 0-7.
Traffic Class Name Enter name for traffic class
Priority Select Low, Medium or High.
IP Precedence Select between 0-7. The lower the digit shows
the higher the priority
IP Type Of Service Select either: Normal Service, Minimize Cost,
Maximize Reliability, Maximize Throughput,
Minimize Delay
Physical LAN Port User can select from: ENET, ENET(1-4).
Protocol User can select from: TCP, TCP/UDP, UDP or
ICMP.
Source IP Address Enter the source IP address.
Source Subnet Mask Enter the subnet mask for the source IP
address.
Source Port (port or port:port) Enter source port number.
Destination IP address Enter destination IP address.
Destination Subnet Mask Enter destination subnet mask.
Destination port (port or
port:port)
Enter destination port number.
802.1p Priority Select between 0-7. The lower the digit shows
the higher the priority
7.6 Routing
The Routing dialog box allows you to configure Default Gateway and Static Route.
7.6.1 Default Gateway
If ‘Enable Automatic Assigned Default Gateway’ checkbox is selected, this
router will accept the first received default gateway assignment from one of the
PPPoA, PPPoE or MER/DHCP enabled PVC(s).
If the checkbox is not selected (as shown below), enter the static default gateway
AND/OR a WAN interface, then click Save/Apply.
NOTE: When enabling the Automatic Assigned Default Gateway, you must
reboot the router to receive the default gateway IP address.
- -
49