User manual

Configure the second IP address by ticking the checkbox shown below.

IP Address: Enter the secondary IP address for the LAN port.

Subnet Mask: Enter the secondary subnet mask for the LAN port.

NOTE: The Save button saves new settings to allow continued configuration

while the Save/Reboot button not only saves new settings but also

reboots the device to apply the new configuration (i.e. all new settings).

Ethernet Media Type: Choose Auto, 10_Half, 10_Full, 100_Half or 100_Full for

each Ethernet port.

7.3 NAT

To display this function, you must enable NAT in WAN Setup.

7.3.1 Virtual Servers

Virtual Server allows you to direct incoming traffic from WAN side (identified by

Protocol and External port) to the Internal server with private IP address on the

LAN side. The Internal port is required only if the external port needs to be

converted to a different port number used by the server on the LAN side. A

maximum 32 entries can be configured.

- -