User`s manual

NOTE : Enable DHCP Server Relay will not display if NAT is enabled.

The user must configure the IP Address and the Subnet Mask. To use the DHCP

service on the LAN, select the Enable DHCP server checkbox, and enter the

Start IP addresses, the End IP address and DHCP lease time. This configures the

router to automatically assign IP addresses, default gateway address and DNS

server addresses to each of your PCs. Select Enable DHCP Server Relay (if

required), and enter the DHCP Server IP Address.

Step 4: The WAN Setup-Summary screen presents the entire configuration

summary. Click Save/Reboot if the settings are correct. Click Back

to modify the settings.