User`s manual

Step 3: Upon completion click Next. The following screen appears.

The Device Setup screen allows the user to configure the LAN interface IP address

and DHCP server. If the user would like this ADSL router to assign dynamic IP

addresses, DNS server and default gateway to other LAN devices, select the radio

box Enable DHCP server on the LAN to enter the starting IP address and end

IP address and DHCP lease time. This configures the router to automatically

assign IP addresses, default gateway address and DNS server addresses to each

of your PCs. Select Enable DHCP Server Relay (if required), and enter the

DHCP Server IP Address.

NOTE 1: Enable DHCP Server Relay will not display if NAT is enabled.

NOTE 2: Ethernet and USB interfaces share the same subnet since they are

bridged within the router.

Step 4: After entering your settings, select Next to display the following screen.

The WAN Setup-Summary screen presents the entire configuration

summary. Click Save/Reboot if the settings are correct. Click Back if

you wish to modify the settings.