User`s manual

SET-2
802.1p Priority Select between 0-7.
Traffic Class Name Enter name for traffic class
Priority Select Low, Medium or High.
IP Precedence Select between 0-7. The lower the digit shows the
higher the priority
Mark IP Type Of Service Select either: Normal Service, Minimize Cost,
Maximize Reliability, Maximize Throughput,
Minimize Delay
Physical LAN Port User can select from: ENET, ENET(1-4), USB,
Wireless or Wireless_Guest.
Protocol User can select from: TCP, TCP/UDP, UDP or ICMP.
Source IP Address Enter the source IP address.
Source Subnet Mask Enter the subnet mask for the source IP address.
Source Port (port or
port:port)
Enter source port number or range.
Destination IP address Enter destination IP address.
Destination Subnet Mask Enter destination subnet mask.
Destination port (port or
port:port)
Enter destination port number or range.
802.1p Priority Select between 0-7. The lower the digit shows the
higher the priority
If the Enable Differentiated Service Configuration box is ticked (i.e. selected)
the following screen will be displayed:
68