User`s manual

Note: If Differentiated Service Configuration
checkbox is selected, you will only need to assign
ATM priority. IP Precedence will not be used for
classification. IP TOS byte will be used for DSCP
mark.
IP Type Of Service Select either: Normal Service, Minimize Cost,
Maximize Reliability, Maximize Throughput,
Minimize Delay
If non-blank value is selected for 'Mark IP
Precedence' and/or 'Mark IP Type Of Service', the
corresponding TOS byte in the IP header of the
upstream packet is overwritten by the selected
value.
Note: If Differentiated Service Configuration
checkbox is selected, you will only need to assign
ATM priority. IP Precedence will not be used for
classification. IP TOS byte will be used for DSCP
mark.
Assign Differentiated Services
Code Point (DSCP) Mark
Choose the required DSCP value. Default value is
“000000”.
Mark 802.1p if 802.1q is
enabled on WAN
Select between 0-7.
Specify Traffic Classification Rules
Enter the following conditions either for physical LAN/Wireless port or for IP level,
SET-1, or for IEEE 802.1p, SET-2
SET-1
Physical LAN Port User can select from: ENET, ENET(1-4), USB,
Wireless or Wireless_Guest.
Protocol User can select from: TCP, TCP/UDP, UDP or ICMP.
Source IP Address Enter the source IP address.
Source Subnet Mask Enter the subnet mask for the source IP address.
Source Port (port or
port:port)
Enter source port number or range.
Destination IP address Enter destination IP address.
Destination Subnet Mask Enter destination subnet mask.
Destination port (port or
port:port)
Enter destination port number or range.
67