Specifications

6
Chapter 3 Router’s configuration
After login, the Quick Setup screen will appear. It is the default screen when no
connections exist. It allows for the configuration of DSL and IP settings.
3.1 Dynamic multi-configuration
3.1.1 Setup WAN port using manual setup
Follow these steps to configure the WAN interfaces.
STEP 1: To Add a new WAN connection, click the Add button.
Heading
Description
VPI/VCI
ATM VPI (0-255) / VCI (32-65535)
Con. ID
WAN connection ID number
Category
ATM service category
Service
Name of the WAN connection
Interface
Name of the interface for WAN
Protocol
Shows the connection type
IGMP
Shows enable or disable IGMP proxy
QoS
Shows if IP QoS is enabled or disabled
VlanId
VLAN ID is used for VLAN Tagging (IEEE 802.1Q)
State
Shows the connection state of the WAN connection
Remove
To remove a connection select the radio button in this column and
click the Remove button under the table.
Edit
Used to edit connections
STEP 2: Adjust the VPI/VCI settings for the connection you wish to establish.
Select Enable Quality Of Service if required. Click Next to continue.