User manual

8
Chapter 2 Installation
2.1 Hardware S etup
Follow the instructions below to complete the hardware setup.
BACK PANEL
The figure below shows the back panel of the device.
ADSL PORT
Connect the ADSL line to the ADSL port with a RJ-11 (telephone) cable.
LAN PORTS
Use RJ-45 cable to connect up to four network devices. These ports are
auto-sensing MDI/X and either straight-through or crossover cable can be used.
ETH WAN PORT
Use RJ45 straight through or crossover MDI/X cable to connect to Ethernet WAN.
USB HOST PORT
The high-speed USB2.0 host connection connects compatible USB devices.
This firmware release supports most printers.
• Consult Appendix E for generic printer setup.
POWER ON
Press the power button to the OFF position (OUT). Connect the power adapter to
the power port. Attach the power adapter to a wall outlet or other AC source. Press
the power button to the ON position (IN). If the Power LED displays as expected
(see section 2.2 LED Indicators
) then the CT-5364A is ready for use.
Caution 1: If the device fails to power up, or it malfunctions, first verify that the
power cords are connected securely and then power it on again. If the
problem persists, contact technical support.
Caution 2: Before servicing or disassembling this equipment, disconnect all power
cords and telephone lines from their outlets.